Unjointed test finger probe 11 of IEC 61032
Model:
- Without force(BND-11);
- 0-50N force(BND-1150);
- 0-75N force(BND-1175).
Additional standards: IEC / EN 60529, IEC 61010, IEC / EN 60335, IEC / EN 60065 and IEC / EN 60950-1.
Product Brief introduction:
The Rigid Test Finger is a precision test probe made according to Figure 7 (Fig. 7) of the IEC 61032 (Test probe 11) and is used to simulate a human finger. It is also used by the standards of CSA, IRAM, UL. IEC 60335, IRAM 4220-1 and in most of the rules involved in the verification of accessibility to live parts.
Access probe for determining the mechanical strength of touchable parts, with integrated compression spring according to standard EN 60335-1 picture 7 and force scale from 0-75 N in 5 N steps.
The test finger with a length of 80 mm is made of stainless steel. According to the regulation, the fingertip corresponds to the dimensions of the movable test finger BND-B according to figure 2 of the standard EN 61032.
A 4 mm connection socket is integrated below the ∅ 50 mm polyamide washer for contact and continuity testing.
The Rigid Test Finger was made on stainless steel and Polyamide handle.
Parameters:
| Probe Finger Diameter | 12mm |
| Probe Finger Length | 80mm |
| Dam- board Diameter | 50mm |
| Dam- board Diameter | 100mm |
| Probe Material | Stainless Steel |
| Handle Material | Polyamide |
| Thrust selection | Without Thrust (BND-11);
0-50N Thrust (BND-1150); 0-75N Thrust (BND-1175) |
| Additional standards | IEC / EN 60529, IEC 61010, IEC / EN 60335, IEC / EN 60065 and IEC / EN |
The standard description:
This probe may be used to verify the protection of persons against access to hazardous parts,
and to verify the mechanical strength of openings in the enclosure or internal barriers.
The following graphs show the penetration depths b and their deviations as a function of the
opening widths a and the tolerance on dimensions b for test probes with tapered sections listed
in this standard:
Figure A.4 – Tolerance range of the penetration depths b through opening width a for
test probe B: jointed test finger and test probe 11: unjointed test finger.
Product Pictures:
- Unjointed test finger probe 11 without thrust.
- Unjointed test finger probe 11 with 50N thrust.
- Unjointed test finger probe 11 with 75N thrust.
All test probes in our company can pass the calibration issued via ISO 17025 / ILAC calibration Metrology institute.
FAQ:
1. Can you provide the ISO 17025 / ILAC calibration certificate?
Yes, we could provide it, but it is not included in our default quotation. If you need this calibration certificate, please inform us additionally when you are place order.
2. How is the package of this unjointed test finger probe 11?
Packed in portable case, easy to keep and carry.
